Intel Xeon Logo
Triumph i7320 (S6621)
 | BIOS | Datasheet | Manual | Quick Ref. |

  Specifications (S6621 - High End Network Security Platform)

 • Two 604-pin sockets support Intel® Xeon®
     processors of the same type listed below:
      - 800 FSB w/ 1M L2 (Nocona), up to 3.6GHz
      - 800 FSB w/ 2M L2 (Irwindale), up to 3.6GHz
 • Separated 4-phase VRD for each CPU

 • Intel E7320 Memory Controller Hub(MCH)
 • Intel 82801EB I/O Controller Hub (ICH5)
 • Two Intel 6700PHX PCI/PCI-X Controller Hub

 • Four 240-pin DDR2 sockets support up to 8 GB
 • Dual ch. memory bus (must populate in pairs)
 • Registered DDR2 400 Compliant ECC DIMM
 • Supports 256MB, 512MB, 1GB, 2GB DIMM
 • Supports standard SEC-DED with 72-bit ECC
     DIMM or supports Intel x4 Single Device Data
     Correction (x4 SDDC)

Expansion Slots
 • One 64-bit 133MHz PCI-X slot (3.3V)
 • Supports up to three devices through riser card

Networking Security
 • Onboard Cavium CN-1120-X Security Macro
     Processor supports IPsec/SSL (optional)

System Management
 • Total three 3-pin fan headers with control and
     tachometer monitoring
 • Monitors voltage for CPU, Mem. & Power Supply
 • Monitoring temperature for CPU & environment
 • Pin header for Fault LED, Power LED & HDD
     activity LED
 • One pin header for Chassis Intrusion detection
 • Supports Serial Console Redirect
 • Private memory chip for security information
 • Supports Watch Dog Timer

Integrated LAN Controllers
 • Four Intel 82546EB dual port Gigabit Controllers
 • Configurable with total 8 Gigabit LAN ports, Max.
     4 of 8 ports could be over Fiber connectors (opt.)

Integrated Graphics
 • Onboard ATI­ RAGE™ XL PCI graphics controller
     with 8MB memory

Integrated I/O
 • One 50-pin Compact Flash Type II connector
 • One 44-pin IDE connector; two SATA connectors
 • One pin header for USB ports
     (supports two USB 2.0 devices)
 • One serial port, one parallel port, one VGA port
 • One pin header for PS/2 mouse and keyboard
 • One pin header for SMBUS connection
 • One pin header for Switch/ LED connection
 • One pin header for Fiber LAN LED display

Back Panel I/O Ports
 • One serial port w/ D-Sub connector
 • Two USB 2.0 ports w/ dual-stack USB connector
 • Eight RJ45 connectors with Transformer and LED
 • Four of eight LAN ports could be configured to
     Optical SPF connectors (optional)

 • AWARD BIOS on 4Mbit Flash ROM
 • Supports ACPI 2.0
 • Supports boot from USB device
 • Power-on mode control for AC power loss recovery

Form Factor
 • EEB 3.51 form factor (12" x 13"; 305x330mm) 

Information published on is subject to change without notice.
Copyright © 2006, TYAN COMPUTER CORPORATION. All Rights Reserved.