Thunder 100  (S1836)  Jumper Settings

Note for Pentium III 600 MHz users.
There is no need to worry about setting the correct jumper settings for a Pentium III 600 MHz because the CPU multiplier is hardwired into the CPU and changing jumper settings will not make any difference.  The BIOS will automatically detect the correct CPU speed that is installed.

Intel Celeron(A) Jumper Settings

Clock Speed

JP9

JP10

JP11

JP12

Multiplier

366MHz

ON

OFF

OFF

OFF

x5.5

400MHz

OFF

ON

ON

ON

x6.0

CPU Settings for 66 MHz Bus

Clock Speed

JP9

JP10

JP11

JP12

Multiplier

233MHz

ON

OFF

OFF

ON

x3.5

266MHz

OFF

ON

ON

ON

x4.0

300MHz

OFF

ON

OFF

ON

x4.5

333MHz

OFF

OFF

ON

ON

x5.0

366MHz**

OFF

OFF

OFF

ON

x5.5

400MHz**

ON

ON

ON

OFF

x6.0

433MHz**

ON

ON

OFF

OFF

x6.5

466MHz**

ON

OFF

ON

OFF

x7.0

** For Intel Celeron processors ONLY

CPU Settings for 100 MHz Bus

Clock Speed

JP9

JP10

JP11

JP12

Multiplier

350MHz

ON

OFF

OFF

ON

x3.5

400MHz

OFF

ON

ON

ON

x4.0

450MHz

OFF

ON

OFF

ON

x4.5

500MHz

OFF

OFF

ON

ON

x5.0

550MHz

OFF

OFF

OFF

ON

x5.5

600MHz***

ON

ON

ON

OFF

x6.0

*** the S1836 only supports the Katmai version of the PIII 600 (refers to
       processors with 100Mhz FSB and 2.0V core).

Line Out Sound Settings

 

With PreAmp (Default)

Without PreAmp

JP32

1-2

2-3

JP33

1-2

2-3

Hardware CMOS / Password Reset

 

Default

Reset

JP3

1-2

2-3

Enabling and Disabling Features

 

Jumper

Enabled

Disabled

Ethernet *

JP31

OFF

ON

Sound *

JP16

OFF

ON

SCSI

JP29

OFF

ON

PCI-PCI Bridge

JP30

OFF

ON

* Ethernet and Sound NOT on S1836DLU  (Default settings disabled).

Information published on Tyan.com is subject to change without notice.
Copyright © 1998-2003, Tyan Computer Corporation. All Rights Reserved.