Trinity KT  (S2390)  Jumper Settings

Note : There are no Jumper settings for CPU bus speed or clock multiplier on the Trinity KT board.  The Trinity KT is designed to automatically detect the socketed Duron™ / Athlon™ CPU and its proper speed settings.

External Pin Assignments (Jumper J1)
 

 

 

 

 
 

HDD LED

VCC

1

2

Power LED+

Pwr/Slp LEDs

LED

3

4

Sleep LED+

Reset Switch

Ground

5

6

Switch

Power Switch

Switch

7

8

Ground

Infrared

IR + 5V

9

10

No Connect

Speaker

No Connect

11

12

VCC

IR RX

13

14

No Connect

IR GND

15

16

No Connect

IR TX

17

18

External Speaker

Power LED (JP22)

Pin

1

2

3
 

+5 VSB
LED YEL

Ground

VCC LED GRN

Note: Jumper JP22 is a 3-pin ACPI LED header.  If you need a 2-pin Power LED header, use Jumper J1 as illustrated on the right.

Clear CMOS and Reset Password (JP21)

Jumper

Normal

Clear

JP21

1-2

2-3

Note : If you have been locked out of your system because you forgot your password or set the CMOS incorrecttly, follow the instructions below:

  1. Power off the system, and disconnect the power supply.
  2. Set jumper JP21 to pin 2 and 3.
  3. Wait for 10 seconds, then return jumper JP21 to pins 1 and 2.
  4. Power on the system again.

By following this procedure, you will erase your password and reset the CMOS to the BIOS defaults.

Information published on Tyan.com is subject to change without notice.
Copyright © 1998-2003, Tyan Computer Corporation. All Rights Reserved.