|
|
Also supports FC-PGA Pentium® III 1.0b GHz CPU. |
|
|
|
350-450MHz with Intel®'s Pentium® II Deschutes |
|
|
|
Intel®'s Celeron - 266-466MHz, Intel®'s Celeron-A (Mendocino) - 300-333MHz |
|
|
|
Older S1854 board revisions with marking "9900Y" or "9900YA" (next to the power supply connector, see ( image ) do NOT support P-III flip chips due to CPU change after initial board production.
Older revisions will only support Pentium® III slot1 processors up to 733 MHz |
|
|
|
Pentium® III 933MHz to 1GHz support applies to S1854 board revisions with marking "99PON" (please refer to the issue
above for mark identification location) and have motherboard revision marking of J or above. (Look on the edge of the board located by the IDE ports for a small white box where revision letter is indicated
inside) |
|
|
|
If you use an old non-Deschutes Pentium® II CPU with BIOS version 1.16b, the onboard IDE controller may not function. |
|
|
|
This board will not work with older non-Deschutes Pentium® II's using the 2.8V core |
|
|
|
Revision of board must be either 3 or 3A |
|
|
|
BIOS rev 2.00 recommended for Coppermine support. BIOS can be downloaded from Tyan's BIOS Support Section. |
|